MiOS Support Center

User Guides

(G1) Placement and G100's Range

Last Updated: Oct 10, 2012 03:02PM PDT

Since it connects either to a computer or a device that's plugged into your computer, your G100 gateway is usually placed nearby to these components.

While your G100's Z-Wave range can travel as far as 100 feet once it's controlling devices (and up to triple that distance outdoors), you need to be much closer than that to make the initial introduction between the devices to include them. There are two ways you can do this:.

 1) If your G100 is plugged into the wall and near your computer, you can bring the devices you want to include within 3 feet of your G100 and do the inclusion from this distance.  Remember that this is only a one-time process and will only take a few seconds.  Once included, you can move the included device further away in your home or even outside..

 2) If you need to include Z-Wave controllable devices that are not easily moved to your G100's location, like a door lock or a thermostat, or a lighting module that needs to be plugged in, you can put the power the G100 with the included batteries and bring it to the needed locations for the inclusion process.



 

To temporarily power your G100 with the included 4 AA batteries, first disconnect the cables (Ethernet and power) and install the batteries into the battery compartment on the bottom of the unit. 

Now press the battery button at the top of your G100.  You'll see it light up, and you're now ready to bring it around the house to devices for the inclusion process.

Again, the inclusion process for a Z-Wave device only happens once and in most cases  you can pretty much forget about it once it's done. Sometimes you may decide to  remove included devices from your system if you choose, and you can do that too.  Now let's look at a simple and typical pairing example with your G100.



NEXT: A Simple Inclusion Example

Contact Us

support@micasaverde.com
http://assets0.desk.com/
mios_ltd
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
Invalid characters found
/customer/en/portal/articles/autocomplete